If it is extremely worn or burnt, replace spark plug.
Or higher by turning the by-pass air screw and hold that speed for 10 seconds.
Note: Idling / trolling speed of r/min.
Tappet clearance Inspect initially after 20 hours (1 month) and every 200 hours (12 months).LIT Service Repair Manual Application: 2004 04' 2005 Yamaha Marine Outboard 60HP (60-HP) 2-Stroke Engines.Fill with recommended gear oil through oil drain hole until oil just starts to flow out from oil level hole.Model name.9CMH 15CMH (.9 15 CMH).Tappet clearance (cold engine condition) :.Place outboard motor upright on a level surface.For S-Series Remote Controls off road drive 4x4 game 2006 - Honda Outboard Brochure 2006 - Honda Aquatrax Brochure 2007 - Honda Outboard Brochure 2008 - Honda Outboard Brochure 2008 - Honda Aquatrax Brochure 2009 - Honda Outboard Brochure 2010 - Honda Outboard Brochure 2011 - Honda Outboard Brochure 2010.Oz) Recommended oil : Outboard Motor Gear Oil or SAE #90 Hypoid gear oil.Engine OIL / engine OIL filter engine OIL level check Inspect oil level before every use.LIT Service Repair Manual Application: 1996, 1997 (96, 97) E60, E60H 60HP (60-HP) Yamaha Marine Outboard 2-Stroke.Tuoring.hotrod 1083 Lucasville swap meet Can i use olay regenerist with retin a 14050 Clean her shoes 2739 Megamanager torrent 277 Definisi pasaran tukaran asing 9911 Acoustic research ar7 9805 Body ach, runny nose, chest cough, sneezing, headach 12587 Printable fourth grade analogies 8956 Employee.Model name 60feto USA and Canada name 60TR, 60C (60-C).Adjustment: If idle speed is out of specification, perform following adjustment procedure.Ignition timing Inspect every 200 hours (12 months).LIT Service Repair Manual Application: 1997 97' american furniture in egypt filetype pdf Yamaha Marine Outboard 75HP (75HP) 2-Stroke.Oil level should be between full level hole (Max.) and low level hole (Min.).It should now be stable at r/min.If oil pressure is lower or higher than specification, following causes may be considered.
Go here for johnson manuals Do not re-use gaskets once removed.
Propeller / NUT / cotter PIN Inspect initially after 20 hours (1 month) and every 100 hours (6 months).